Deleting A Traffic Control Interface; Managing Traffic Control Priorities; Viewing A List Of Traffic Control Priorities - Siemens RUGGEDCOM ROX II User Manual

Chapter 5
Setup and Configuration
Section 5.39.2.3

Deleting a Traffic Control Interface

To delete a traffic control interface, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the traffic control interface by typing:
no qos traffic-control basic-configuration tcinterfaces interface
Where:
• interface is the name of the traffic control interface
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.39.3

Managing Traffic Control Priorities

Traffic control priorities define priorities used for traffic shaping.
NOTE
Traffic control priorities can only be configured in basic mode. For more information about setting the
traffic control mode, refer to
The following sections describe how to configure and manage traffic control priorities:
• Section 5.39.3.1, "Viewing a List of Traffic Control Priorities"
• Section 5.39.3.2, "Adding a Traffic Control Priority"
• Section 5.39.3.3, "Deleting a Traffic Control Priority"
Section 5.39.3.1

Viewing a List of Traffic Control Priorities

To view a list of traffic control priorities, type:
show running-config qos traffic-control basic-configuration tcpriorities
If priorities have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config qos traffic-control basic-configuration tcpriorities
qos
traffic-control
basic-configuration
tcpriorities high
band high
protocol tcp
port 80
description "High priority traffic"
!
tcpriorities medium
protocol udp
port 1500
description "Medium priority traffic"
!
tcpriorities low
570
Section 5.39.1, "Enabling and Configuring Traffic
RUGGEDCOM ROX II
CLI User Guide
Control".
Deleting a Traffic Control Interface