Acknowledging Alarms; Configuring An Alarm - Siemens RUGGEDCOM ROX II User Manual

Chapter 4
System Administration
Section 4.6.3.2

Acknowledging Alarms

To acknowledge all active alarms, type:
admin acknowledge-all-alarms
Alternatively, to acknowledge an individual alarm, type:
admin alarms active-alarms type id event acknowledge
Where:
• type is the type of alarm. Options include admincellmodemchassisethsecurityswitchwan.
• id is the ID for the chosen alarm
• event is the ID for the chosen event
Section 4.6.4

Configuring an Alarm

While all alarms are pre-configured on the device, some alarms can be modified to suit the application. This
includes changing the severity and enabling/disabling certain features.
NOTE
The failrelay-enable and led-enable parameters are non-configurable for link up alarms.
To configure an alarm, do the following:
1. Make sure the CLI is in Configuration mode.
2. Configure the alarm by typing:
admin alarm-config type alarm-list id
Where:
• type is the type of alarm. Options include admincellmodemchassisethsecurityswitchwan.
• id is the ID for the chosen alarm
3. Configure the following parameters as required:
NOTE
Depending on the alarm type, some parameters are not available.
Parameter
description { description }
severity { severity }
admin-enable
164
Description
Synopsis: A string 1 to 127 characters long
The name of the alarm.
Synopsis: { emergency, alert, critical, error, warning, notice,
info, debug }
The severity level can be one of emergency, alert, critical, error,
warning, notice, info, and debug. This cannot be changed for
some alarms.
Synopsis: typeless
RUGGEDCOM ROX II
CLI User Guide
Acknowledging Alarms