Adding A Nat Setting; Deleting A Nat Setting - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Section 5.17.12.2

Adding a NAT Setting

To configure a Network Address Translation (NAT) entry, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the entry by typing:
security firewall fwconfig firewall fwnat name
Where:
• firewall is the name of the firewall
• name is the name of the network address translation entry
3. Configure the following parameter(s) as required:
Parameter
external-addr { external-addr }
interface { interface }
ipalias
internal-addr { internal-addr }
limit-interface
local
description { description }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 5.17.12.3

Deleting a NAT Setting

To delete a network address translation entry, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the entry by typing:
no security firewall fwconfig firewall fwnat name
Where:
• firewall is the name of the firewall
• name is the name of the network address translation entry
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Adding a NAT Setting
Description
Synopsis: A string
The external IP Address. The address must not be a DNS name.
External IP addresses must be manually added to the interface.
An interface that has an external IP address.
Synopsis: typeless
Create IP Alias for NAT rule.
Synopsis: A string
The internal IP address. The address must not be a DNS Name.
Synopsis: typeless
Translation only effective from the defined interface.
Synopsis: typeless
Translation effective from the firewall system.
Synopsis: A string
(Optional) The description string for this NAT entry.
Chapter 5
Setup and Configuration
287