RUGGEDCOM ROX II
CLI User Guide
routing rip network neighbor address
Where:
• address is the IP address of the neighbor
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.20.7.3
Deleting a Neighbor
To delete a neighbor from a RIP network, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Delete the network by typing:
no routing rip network neighbor address
Where:
• address is the IP address of the neighbor
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.20.8
Managing the Prefix List Distribution
The following sections describe how to configure and manage the prefix list distribution:
•
Section 5.20.8.1, "Viewing a List of Prefix List Distribution Paths"
•
Section 5.20.8.2, "Adding a Prefix List Distribution Path"
•
Section 5.20.8.3, "Deleting a Prefix List Distribution Path"
Section 5.20.8.1
Viewing a List of Prefix List Distribution Paths
To view a list of prefix list distribution paths for dynamic RIP routes, type:
show running-config routing rip distribute-prefix-list
If distribution paths have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing rip distribute-prefix-list
routing rip
distribute-prefix-list out ""
prefix-list list-permit-lan-22
!
!
If no prefix list distribution paths have been configured, add distribution paths as needed. For more information,
refer to
Section 5.20.8.2, "Adding a Prefix List Distribution
Deleting a Neighbor
Path".
Chapter 5
Setup and Configuration
349