Adding An Egress Mark - Siemens RUGGEDCOM ROX II User Manual

Chapter 5
Setup and Configuration
If no egress marks have been configured, add egress marks as needed. For more information, refer to
Section 5.39.8.2, "Adding an Egress
Section 5.39.8.2

Adding an Egress Mark

To add an egress mark for a QoS Map, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the QoS map by typing:
• For Switched Ethernet Ports
interface switch vlans all-vlans id qosmap priority egress mark
Where:
▪ id is the ID given to the VLAN
▪ priority is the priority assigned to the QoS map
▪ mark is the value of the egress mark
• For Routable-Only Ethernet Ports
interface eth slot port vlan id qosmap priority egress mark
Where:
▪ slot is the name of the module location
▪ port is the port number (or a list of ports, if aggregated in a port trunk) for the module
▪ id is the ID given to the VLAN
▪ priority is the priority assigned to the QoS map
▪ mark is the value of the egress mark
• For Virtual Switches
interface virtualswitch id vlan vlan-id qosmap priority egress mark
Where:
▪ slot is the name of the module location
▪ port is the port number (or a list of ports, if aggregated in a port trunk) for the module
▪ id is the ID given to the VLAN
▪ priority is the priority assigned to the QoS map
▪ mark is the value of the egress mark
• For WAN Interfaces
interface wan slot port vlan id qosmap priority egress mark
Where:
▪ slot is the name of the module location
▪ port is the port number (or a list of ports, if aggregated in a port trunk) for the module
▪ id is the ID given to the VLAN
▪ priority is the priority assigned to the QoS map
588
Mark".
RUGGEDCOM ROX II
CLI User Guide
Adding an Egress Mark