Chapter 5
Setup and Configuration
• id is the ID of the key
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.20.10
Managing Redistribution Metrics
Redistribution metrics redistribute routing information from other routing protocols, static routes or routes handled
by the kernel. Routes for subnets that are directly connected to the router, but not part of the RIP networks, can
also be advertised.
The following sections describe how to configure and manage redistribution metrics:
•
Section 5.20.10.1, "Viewing a List of Redistribution Metrics"
•
Section 5.20.10.2, "Adding a Redistribution Metric"
•
Section 5.20.10.3, "Deleting a Redistribution Metric"
Section 5.20.10.1
Viewing a List of Redistribution Metrics
To view a list of redistribution metrics for dynamic RIP routes, type:
show running-config routing rip redistribute
If metrics have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing rip redistribute
routing rip
redistribute bgp
no metric
!
!
If no redistribution metrics have been configured, add metrics as needed. For more information, refer to
Section 5.20.10.2, "Adding a Redistribution
Section 5.20.10.2
Adding a Redistribution Metric
To add a redistribution metric for dynamic RIP routes, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Add the metric by typing:
routing rip redistribute [ bgp | ospf | connected | static | kernel ]
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
354
Metric".
RUGGEDCOM ROX II
CLI User Guide
Managing Redistribution Metrics