RUGGEDCOM ROX II
CLI User Guide
Section 5.43.3.1
Viewing a List of Network Addresses
To view a list of network addresses, type:
show running-config apps elan database addresses
If addresses have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config apps elan database addresses | tab
ADDRESS
-------------------------------------
172.155.24.12
172.155.24.13
172.155.24.27
!
If no network addresses have been configured, add addresses as needed. For more information, refer to
Section 5.43.3.2, "Adding a Network
Section 5.43.3.2
Adding a Network Address
To add a network address, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Add the network address by typing:
apps elan database addresses address
Where:
• address is the IPv4 network address
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.43.3.3
Deleting a Network Address
To delete a network address, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Delete the network address by typing:
no apps elan database addresses address
Where:
• address is the IPv4 network address
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Viewing a List of Network Addresses
Address".
Chapter 5
Setup and Configuration
619