Chapter 5
Setup and Configuration
2.
Delete the address by typing:
no routing bgp aggregate-address address
Where:
• address is the subnet address and prefix for the aggregate address
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.19.10
Managing Aggregate Address Options
The following sections describe how to configure and manage options for aggregate addresses:
•
Section 5.19.10.1, "Viewing a List of Aggregate Address Options"
•
Section 5.19.10.2, "Adding an Aggregate Address Option"
•
Section 5.19.10.3, "Deleting an Aggregate Address Option"
Section 5.19.10.1
Viewing a List of Aggregate Address Options
To view a list of options for an aggregate address, type:
routing bgp aggregate-address address options
If options have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing bgp aggregate-address 11.11.0.0/16 options
routing bgp
aggregate-address 11.11.0.0/16
options summary-only
!
!
!
If no options have been configured, add options as needed. For more information, refer to
"Adding an Aggregate Address
Section 5.19.10.2
Adding an Aggregate Address Option
To add an option for an aggregate address, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Add the path by typing:
routing bgp aggregate-address address options [ summary-only | as-set ]
Where:
• address is the subnet address and prefix for the aggregate address
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
336
Option".
RUGGEDCOM ROX II
CLI User Guide
Section 5.19.10.2,
Managing Aggregate Address Options