RUGGEDCOM ROX II
CLI User Guide
To configure the internal VLAN range, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Navigate to admin » switch-config and configure the following parameter(s) as required:
Parameter
enabled
range-start { range-start }
range-end { range-end }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.37.3
Managing VLANs for Switched Ethernet Ports
The following sections describe how to configure and manage VLANs specifically for switched Ethernet ports:
•
Section 5.37.3.1, "Viewing VLAN Assignments for Switched Ethernet Ports"
•
Section 5.37.3.2, "Configuring VLANs for Switch Ethernet Ports"
Section 5.37.3.1
Viewing VLAN Assignments for Switched Ethernet Ports
To determine which VLANs are assigned to each switched Ethernet port, type:
show switch vlans vlan-summary
A table similar to the following example appears:
ruggedcom# show switch vlans vlan-summary
IGMP
VID
SNOOPING
MSTI
-------------------------------------------------------------------------
1
false
0
Managing VLANs for Switched Ethernet Ports
Description
Synopsis: true or false
Default: false
Enables/disables the Internal VLAN Range settings.
Synopsis: An integer between 2 and 4094
Default: 4094
Prerequisite: range-start must be less than or equal to range-end
Defines the lower end of a range of VLANs used for the device only. VLAN ID 1 is not
permitted.
Synopsis: An integer between 2 and 4094
Default: 4094
Prerequisite: range-end must be greater than or equal to range-start
Defines the higher end of a range of VLANs used for the device only.VLAN ID 1 is not
permitted.
UNTAGD
UNTAGD
TAGGED
SLOT
PORTS
SLOT
sm
none
lm1
1,2
lm2
none
lm3
none
lm4
none
lm5
none
lm6
none
sm
lm1
lm2
TAGGED
PORTS
QOS
INGRESS
none
none
none
Setup and Configuration
MARK
Chapter 5
549