Table of Contents
Advertisement
RUGGEDCOM ROX II
CLI User Guide
Section 3.12.2
Installing an Application
To install an application, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Make sure a repository for the application has been configured before installing the application. For more
information, refer to
3.
Install the application by typing:
admin software-upgrade apps install-app app-name name
Where:
• name is the name of the application to install as it appears in the repository configuration. To install more
than one application, use a comma seperated list.
Section 3.12.3
Upgrading an Application
To upgrade an application, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Install the application by typing:
admin software-upgrade apps upgrade-app app-name name
Where:
• name is the name of the application to upgrade as it appears in the repository configuration. To upgrade
more than one application, use a comma seperated list.
Section 3.12.4
Uninstalling an Application
To uninstall an application, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Install the application by typing:
admin software-upgrade apps uninstall-app app-name name
Where:
• name is the name of the application to uninstall as it appears in the repository configuration. To uninstall
more than one application, use a comma seperated list.
Installing an Application
Section 3.12.5.3, "Adding a
Repository".
Chapter 3
Device Management
79
Advertisement
Table of Contents
Troubleshooting
