Chapter 5
Setup and Configuration
The following sections describe how to configure and manage traffic control devices:
•
Section 5.39.5.1, "Viewing a List of Traffic Control Devices"
•
Section 5.39.5.2, "Adding a Traffic Control Device"
•
Section 5.39.5.3, "Deleting a Traffic Control Device"
Section 5.39.5.1
Viewing a List of Traffic Control Devices
To view a list of traffic control devices, type:
show running-config qos traffic-control advanced-configuration tcdevices
If devices have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config qos traffic-control advanced-configuration tcdevices
qos
traffic-control
advanced-configuration
tcdevices te1-2-1c01ppp
inbandwidth
in-unit
outbandwidth 1500
out-unit
!
!
!
!
If no devices have been configured, add devices as needed. For more information, refer to
"Adding a Traffic Control
Section 5.39.5.2
Adding a Traffic Control Device
To add a new traffic control device, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Add the traffic control device by typing:
qos traffic-control advanced-configuration tcdevices name
Where:
• name is the name of the interface to which traffic shaping will apply. Lowercase alphanumerical as well as
'.' and '-' characters are allowed.
3.
Configure the following parameter(s) as required:
Parameter
{ interface }
iptype { iptype }
576
1500
kilobits
kilobits
Device".
Description
Synopsis: A string 1 to 15 characters long
An interface to which traffic shaping will apply. Lowercase alphanumerical as well as '.'
and '-' characters are allowed.
Synopsis: { ipv4, ipv6, ipv4ipv6 }
Default: ipv4
RUGGEDCOM ROX II
CLI User Guide
Section 5.39.5.2,
Viewing a List of Traffic Control Devices