Chapter 5
Setup and Configuration
Section 5.22.8.1
Viewing a List of IP/VPN Tunnels
To view a list of IP/VPN tunnels configured for VRF, type:
show running-config routing bgp address-family vpnv4
A table or list similar to the following example appears:
ruggedcom# show running-config routing bgp address-family vpnv4 | tab
routing bgp
address-family vpnv4
neighbor
SEND
IP
COMMUNITY
--------------------
1.2.6.2
both
!
!
Section 5.22.8.2
Adding an IP/VPN Tunnel
To add a new IP/VPN tunnel for VRF, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Add the neighbor by typing:
routing bgp address-family vpnv4 neighbor address send-community [ both | extended | none |
standard ]
Where:
• address is the IP address of the neighbor
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.22.8.3
Deleting an IP/VPN Tunnels
To delete an IP/VPN tunnel, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Delete the address by typing:
no routing bgp address-family vpnv4 neighbor address
Where:
• address is the IP address of the neighbor
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
390
RUGGEDCOM ROX II
CLI User Guide
Viewing a List of IP/VPN Tunnels