Table of Contents
Advertisement
Chapter 5
Setup and Configuration
1.
Make sure the CLI is in Configuration mode.
2.
Navigate to security » firewall » fwconfig » fwconfig » {firewall} » fwinterface{interface} » zone, where
{firewall} is the name of the firewall and {interface} is the name of the interface.
3.
Configure the following parameter(s) as required:
Parameter
predefined-zone { predefined-zone }
undefined-zone
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 5.17.9.4
Configuring a Broadcast Address
To configure a broadcast address for an interface, do the following:
1.
Make sure the CLI is in Configuration mode.
Navigate to security » firewall » fwconfig » fwconfig » {firewall} » fwinterface{interface} » broadcast-
2.
addr, where {firewall} is the name of the firewall and {interface} is the name of the interface.
3.
Configure the following parameter(s) as required:
Parameter
ipv4-address { ipv4-address }
detect
none
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 5.17.9.5
Deleting an Interface
To delete an interface, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Delete the interface by typing:
no security firewall fwconfig firewall fwinterface name
Where:
• firewall is the name of the firewall
• name is the name of the interface
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
280
Description
A pre-defined zone
This is used in conjunction with hosts definitions.
Description
Synopsis: A string
An IPv4 address for a broadcast address.
Automatic detection of the broadcast address(es).
The default.
RUGGEDCOM ROX II
CLI User Guide
Configuring a Broadcast Address
Advertisement
Table of Contents
Troubleshooting
