Configuring The Distribution Of Prefix Lists; Tracking Commands - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Parameter
in { in }
out { out }
5. Configure the prefix list distribution. For more information, refer to
Distribution of Prefix
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
6.
Section 5.22.12.3

Configuring the Distribution of Prefix Lists

To configure the distribution of prefix lists for a neighbor in an IPv4 address family, do the following:
1. Make sure the CLI is in Configuration mode.
2. Apply the desired prefix list the chosen route direction (incoming or outbound) by typing:
routing bgp address-family ipv4 vrf vrf neighbor address distribute-prefix-list [ in | out ]
prefix-list prefix
Where:
• vrf is the chosen VRF instance
• address is the address of the chosen neighbor
• prefix is the chosen BGP prefix list
3. If necessary, configure an event tracker to track network commands. For more information, refer to
Section 5.22.12.4, "Tracking
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 5.22.12.4

Tracking Commands

Network commands can be tracked using event trackers configured under global » tracking. For more
information about event trackers, refer to
A network command is activated based on the event tracker's state. The apply-when parameter determines
when the command is activated. For example, if the apply-when parameter is set to down, the network
command becomes active (thereby advertising the network to a router's RIP peers) when the tracked target is
unavailable.
To track a command for an IPv4 address family, do the following:
1. Make sure the CLI is in Configuration mode.
2. Navigate to routing » dynamic » bgp » address-family » ipv4 » {vrf} » neighbor » {address} »
distribute-prefix-list » In|out, where {vrf} is the chosen VRF instance and {address} is the IP address of the
neighbor.
3. Configure the following parameter(s) as required:
Configuring the Distribution of Prefix Lists
Lists".
Commands".
Section 3.16, "Managing Event
Description
Apply route map to incoming routes.
Apply route map to outbound routes.
Section 5.22.12.3, "Configuring the
Trackers".
Chapter 5
Setup and Configuration
397