Adding A Vlan To A T1/E1 Line; Deleting A Vlan For A Routable Ethernet Port - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
4. Add a QoS map for the VLAN. For more information, refer to
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
5.
Section 5.37.8.4

Adding a VLAN to a T1/E1 Line

To add a VLAN to a T1/E1 line, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the new VLAN by typing:
interface wan slot port protocol channel number connection hdlc-eth vlan id
Where:
• slot is the name of the module location
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module
• protocol is either T1 or E1
• number is the channel number
• id is the ID of the VLAN
3. Configure the following parameter(s) as required:
Parameter
on-demand
mtu { mtu }
ip-address-src { ip-address-src }
4. Add a QoS map for the VLAN. For more information, refer to
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
5.
Section 5.37.8.5

Deleting a VLAN for a Routable Ethernet Port

To delete a VLAN configured for either a routable Ethernet port or virtual switch, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the traffic control rule by typing:
no interface eth name vlan id
Adding a VLAN to a T1/E1 Line
Section 5.39.7.2, "Adding a QoS
Description
Synopsis: typeless
This interface is up or down on demand of link fail over.
Synopsis: An integer between 256 and 1500
Default: 1500
Maximum transmission unit (largest packet size allowed for this
interface).
Synopsis: { static, dynamic }
Default: static
Whether the IP address is static or dynamically assigned via
DHCP or BOOTP. The DYNAMIC option is a common case of a
dynamically assigned IP address. It switches between BOOTP
and DHCP until it gets the response from the relevant server. It
must be static for non-management interfaces
Section 5.39.7.2, "Adding a QoS
Chapter 5
Setup and Configuration
Map".
Map".
559