Viewing The Status Of The Link-State Database - Siemens RUGGEDCOM ROX II User Manual

Chapter 5
Setup and Configuration
Parameter
SNPA
Section 5.18.4

Viewing the Status of the Link-State Database

To view the basic status of the link-state database for the IS-IS network, do the following:
1. Make sure IS-IS is configured. For more information, refer to
2. Display the basic status by typing:
routing status isis isis-database-status
Or display a more detailed status by typing:
routing status isis isis-database-detail-status
If IS-IS routes have been configured, a list similar to the following example appears:
ruggedcom# routing status isis isis-database-status
isis-database-status
Area area1:
IS-IS Level-1 link-state database:
LSP ID
R1.00-00
1 LSPs
IS-IS Level-2 link-state database:
LSP ID
Spirent-.00-00
R1.00-00
Spirent-right.00-00
Spirent-right.00-01
Spirent-right.00-00
Spirent-right.00-01
Spirent-right.00-00
Spirent-right.00-01
Spirent-right.00-00
Spirent-right.00-01
Spirent-right.00-00
Spirent-right.00-01
298
PduLen SeqNumber
* 75 0x00000015
PduLen SeqNumber
121 0x0000000f
* 75 0x00000015
1465 0x0000000f
295 0x0000000f
1465 0x0000000f
287 0x0000000f
1462 0x0000000f
269 0x0000000f
1463 0x0000000f
261 0x0000000f
1460 0x0000000f
253 0x0000000f
Description
The MAC address of the Sub-Network Point of Attachment
(SNPA).
Section 5.18.2, "Configuring
Chksum Holdtime ATT/P/OL
0xe43a 1129 0/0/0
Chksum Holdtime ATT/P/OL
0xd5e6 871 0/0/0
0xe636 1031 0/0/0
0x3d65 871 0/0/0
0x6a0d 872 0/0/0
0x4638 872 0/0/0
0x54d0 872 0/0/0
0x6528 872 0/0/0
0x7e8a 872 0/0/0
0x99a0 872 0/0/0
0xb0d2 872 0/0/0
0x80c6 872 0/0/0
0x97fb 872 0/0/0
Viewing the Status of the Link-State Database
RUGGEDCOM ROX II
CLI User Guide
IS-IS".