Chapter 5
Setup and Configuration
Section 5.20.6.3
Deleting a Network Interface
To delete an interface from a RIP network, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Delete the network by typing:
no routing rip network interface name
Where:
• name is the name of the interface
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.20.7
Managing Neighbors
Neighbors are other routers with which to exchange routes.
The following sections describe how to configure and manage neighbor IP addresses for dynamic RIP routes:
•
Section 5.20.7.1, "Viewing a List of Neighbors"
•
Section 5.20.7.2, "Adding a Neighbor"
•
Section 5.20.7.3, "Deleting a Neighbor"
Section 5.20.7.1
Viewing a List of Neighbors
To view a list of neighbors configured for a RIP network, type:
show running-config routing rip network neighbor
If neighbors have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing rip network neighbor
routing rip
network neighbor 192.168.33.2
!
!
If no neighbors have been configured, add neighbors as needed. For more information, refer to
"Adding a
Neighbor".
Section 5.20.7.2
Adding a Neighbor
To add a neighbor for a RIP network, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Add the neighbor by typing:
348
RUGGEDCOM ROX II
CLI User Guide
Section 5.20.7.2,
Deleting a Network Interface