Table of Contents
Advertisement
RUGGEDCOM ROX II
CLI User Guide
Section 5.28.5.3
Deleting a Link Failover Ping target
To delete a link failover ping target, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Delete the backup interface by typing:
no services link-failover interface target address
Where:
• interface is the name of the interface
• address is the IP address of the target host to verify the main path
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.28.6
Testing Link Failover
The link failover settings can be tested to confirm that each link failover configuration works properly. To launch
the test, specify for how long the system should operate on the backup interface, and for how long the system
should delay before starting the test. Canceling the test returns the interfaces to their pre-test condition.
While the test is running, monitor the status of the test to observe the main and backup link status, ping test
results, state change, backup state, and backup interface information. As the test progresses, this information
changes as link failover switches from the main interface to the backup interface. For more information on the
Link Fail Over Status form, refer to
To launch a link failover test, do the following:
NOTE
The link failover test can be canceled at any time. For more information about canceling a link failover
test, refer to
Canceling the test returns the interfaces to their pre-test condition.
1.
Make sure the CLI is in Configuration mode.
2.
Start the test by typing:
services link-failover interface start-test start-test-delay delay test-duration duration
Where:
• interface is the name of the interface
• delay is the time (in seconds) to wait before running the test
• duration is the maximum time (in minutes) to run the test before restoring service to the main trunk
Section 5.28.7
Canceling a Link Failover Test
To cancel a link failover test, type:
Deleting a Link Failover Ping target
Section 5.28.2, "Viewing the Link Failover
Section 5.28.7, "Canceling a Link Failover
Status".
Test".
Chapter 5
Setup and Configuration
455
Advertisement
Table of Contents
Troubleshooting
