Siemens RUGGEDCOM ROX II User Manual page 133

RUGGEDCOM ROX II
CLI User Guide
Parameter
NOTE
Multicast filtering, CoS and VLAN parameters are only available when the port is in switchport
mode.
6. Configure the Multicast filtering settings by configuring the following parameter(s) as required:
Parameter
gmrp { gmrp }
7. Configure the CoS settings by configuring the following parameter(s) as required:
Parameter
default-priority { default-priority }
inspect-tos
8. Configure the VLAN settings by configuring the following parameter(s) as required:
Parameter
pvid { pvid }
type { type }
Configuring a Switched Ethernet Port
Description
Disabling notifications will prevent sending notifications and
generating alarms for a particular interface from the LLDP agent.
Description
Synopsis: { advertise_only, learn_advertise }
GMRP (GARP Multicast Registration Protocol) operation
on the port. There are several GMRP operation modes:
<itemizedlist><listitem>DISABLED : the port is not capable
of any GMRP processing.</listitem> <listitem>ADVERTISE
ONLY : the port will declare all MCAST addresses existing in
the switch (configured or learned) but will not learn any MCAST
addresses.</listitem> <listitem>ADVERTISE and LEARN : the
port will declare all MCAST Addresses existing in the switch
(configured or learned) and can dynamically learn MCAST
addresses.</listitem></itemizedlist>
Description
Synopsis: An integer between 0 and 7
Default: 0
The priority of frames received on this port that are not prioritized
based on the frame's contents (e.g. the priority field in the VLAN
tag, DiffServ field in the IP header, prioritized MAC address).
Synopsis: typeless
Enables or disables parsing of the Type-of-Service (ToS) field in
the IP header of the received frames to determine what Class
of Service (CoS) they should be assigned. When ToS parsing is
enabled the switch will use the differentiated services bits in the
TOS field.
Description
Synopsis: An integer between 1 and 4094
The Port VLAN Identifier specifies the VLAN ID associated with
untagged (and 802.1p priority tagged) frames received on this
port. Frames tagged with a non-zero VLAN ID will always be
associated with the VLAN ID retrieved from the frame tag.
Synopsis: { edge, trunk, pvlanedge }
Default: edge
How the port determines its membership in VLANs. There are a
few types of ports: <itemizedlist><listitem>EDGE : the port is only
a member of one VLAN (its native VLAN specified by the 'PVID'
parameter).</listitem> <listitem>PVLAN Edge : the port does
not forward traffic to other PVLAN edge ports within the same
VLAN.</listitem> <listitem>TRUNK : the port is automatically a
member of all configured VLANs. Frames transmitted out of the
Chapter 3
Device Management
95