Siemens RUGGEDCOM ROX II User Manual page 80

Chapter 2
Using RUGGEDCOM ROX II
Parameter
save filename
show
top command
validate
wizard [ rox_flash | rox_upgrade ]
42
Description
reaching the maximum number of old configurations, storing a new
configuration deletes the oldest configuration in the list. The most
recently committed configuration (the running configuration) appears
as item 0 in the list. Select a number from the list and press Enter.
ruggedcom(config)# rollback configuration
Possible completions:
0 2012-01-08 13:51:46 by admin via cli
1 2012-01-08 13:50:58 by admin via cli
2 2012-01-08 12:05:46 by admin via cli
3 2012-01-08 10:47:42 by admin via cli
4 2012-01-08 07:49:38 by admin via cli
5 2012-01-08 07:46:14 by admin via cli
ruggedcom(config)# rollback configuration
After rolling back the configuration, use the commit command to
commit the changes.
Saves the current configuration, without default values, to an ASCII
file. Specify a filename for the file.
Current configuration means the configuration of the user's current
level in the configuration data hierarchy. For example, if the user
is at the top level, the save command will save the complete/full
configuration of the device.
ruggedcom(config)# save {full-configuration-
filename}
If the user is at a level other than the top level, such as the firewall
level, the save command will save a partial configuration of the
current level.
ruggedcom(config)#security firewall
ruggedcom(config-firewall)# save {firewall-
configuration-filename}
Use this command along with the details command to include
default values in the saved configuration file. For example:
ruggedcom(config)# save {filename} | details
Shows configuration, history or command line interface parser
information. Type show and press Tab to navigate through the items
available to display.
This command can also be combined with the details command
to display the default configuration values. For example:
ruggedcom# show running-config admin session-
limits | details
Exits to the top level of the command hierarchy and, optionally, runs
a command.
Validates the current configuration.
Runs the rox_flash or rox_upgrade wizards. For more information,
refer to Section 3.11.5.2, "Downgrading Using ROXflash"
Section 3.11.3, "Upgrading the RUGGEDCOM ROX II
Configuration Mode General Commands
RUGGEDCOM ROX II
CLI User Guide
and
Software".