Table of Contents
Advertisement
Chapter 5
Setup and Configuration
•
Section 5.19.4.2, "Viewing a List of Excluded Autonomous System Paths"
•
Section 5.19.4.3, "Adding a Prepended Autonomous System Path Filter"
•
Section 5.19.4.4, "Adding an Excluded Autonomous System Path filter"
•
Section 5.19.4.5, "Deleting a Prepended Autonomous System Path Filter"
•
Section 5.19.4.6, "Deleting an Excluded Autonomous System Path Filter"
Section 5.19.4.1
Viewing a List of Prepended Autonomous System Path Filters
To view a list of prepended autonomous system path filters configured for a BGP route map entry, type:
show running-config routing bgp filter route-map name entry number set as-path prepend
Where:
• name is the name of the route map
• number is the entry number
If filters have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing bgp filter route-map route entry 10 set as-path prepend
routing bgp
filter route-map route
entry 10
set as-path prepend 120
!
!
!
!
If no prepended autonomous system path filters have been configured, add filters as needed. For more
information, refer to
Section 5.19.4.2
Viewing a List of Excluded Autonomous System Paths
To view a list of excluded autonomous system path filters configured for a BGP route map entry, type:
show running-config routing bgp filter route-map name entry number set as-path exclude
Where:
• name is the name of the route map
• number is the entry number
If filters have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing bgp filter route-map route entry 10 set as-path exclude
routing bgp
filter route-map route
entry 10
set as-path exclude 110
!
!
!
!
322
Section 5.19.4.3, "Adding a Prepended Autonomous System Path
Filter".
Viewing a List of Prepended Autonomous System Path
RUGGEDCOM ROX II
CLI User Guide
Filters
Advertisement
Table of Contents
Troubleshooting
