Adding A Shared Network; Configuring Shared Network Options - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
dhcpserver
shared-network Shared
options client
no hostname
no subnetmask
no default-route
no broadcast
no domain
no dns-server
no static-route
no nis server
no nis domain
!
!
!
!
If no shared networks have been configured, add shared networks as needed. For more information, refer to
Section 5.15.6.2, "Adding a Shared
Section 5.15.6.2

Adding a Shared Network

To add a shared network to the DHCP server, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the shared network by typing:
services dhcpserver shared-network name
Where:
• name is the name of the shared network
3. Configure options for the shared network. For more information, refer to
Shared Network
4. Configure the client for the shared network. For more information, refer to
Shared Network
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
5.
Section 5.15.6.3

Configuring Shared Network Options

To configure options for a shared network on the DHCP server, do the following:
NOTE
Options set at the shared network level override options set at the DHCP server level.
1. Make sure the CLI is in Configuration mode.
2. Configure the following parameter(s) as required:
Parameter
unknown-client { unknown-client }
Adding a Shared Network
Network".
Options".
Client".
Description
Synopsis: { allow, deny, ignore }
Setup and Configuration
Section 5.15.6.3, "Configuring
Section 5.15.6.4, "Configuring a
Chapter 5
241