Enabling/Disabling Mpls Routing; Managing The Mpls Interfaces - Siemens RUGGEDCOM ROX II User Manual

Chapter 5
Setup and Configuration
A table or list similar to the following example appears:
ruggedcom# show mpls status forwarding-table
LOCAL OUTGOING
LABEL LABEL
------------------------------------------------------------------------
17 Pop
18 Pop
19 Pop
20 Pop
21 Pop
22 Pop
This table or list provides the following information:
Parameter
local-label
outgoing-label
prefix
outgoing-interface
next-hop
uptime
Section 5.41.3

Enabling/Disabling MPLS Routing

To enable MPLS routing, do the following:
1. Make sure the CLI is in Configuration mode.
2. Enable or disable MPLS by typing the following commands:
Enable
mpls enable
Disable
no mpls enable
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.41.4

Managing the MPLS Interfaces

The following sections describe how to manage the MPLS interfaces:
600
OUTGOING
PREFIX INTERFACE
1.1.1.1/32 switch.0010
2.2.2.2/32 switch.0010
5.5.5.5/32 switch.0020
6.6.6.6/32 switch.0020
192.168.100.0/24 switch.0010
192.168.200.0/24 switch.0020
NEXT HOP UPTIME
192.168.10.1 01:04:31
192.168.10.1 01:04:31
192.168.20.2 01:04:33
192.168.20.2 01:04:33
192.168.10.1 01:04:31
192.168.20.2 01:04:33
Description
Synopsis: A string
The incoming (local) label
Synopsis: A string
The outgoing (remote) label.
Synopsis: A string
The destination address prefix.
Synopsis: A string
The outgoing interface.
Synopsis: A string
The destination next hop router.
Synopsis: A string
The time this entry has been up.
RUGGEDCOM ROX II
CLI User Guide
Enabling/Disabling MPLS Routing