Adding A Zone - Siemens RUGGEDCOM ROX II User Manual

Chapter 5
Setup and Configuration
• firewall is the name of the firewall
If zones have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config security firewall fwconfig fwzone
security
firewall
fwconfig firewall
fwzone fw
type firewall
description FirewallZone
!
fwzone man
description IPv4Zone
!
!
!
!
If no zones have been configured, add zones as needed. For more information, refer to
a Zone".
Section 5.17.8.2

Adding a Zone

To add a new zone for a firewall, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the zone by typing:
security firewall fwconfig firewall fwzone zone
Where:
• firewall is the name of the firewall
• zone is the name of the zone
3. Configure the following parameter(s) as required:
Parameter
iptype { iptype }
type46 { type46 }
type6 { type6 }
type { type }
276
Description
Synopsis: { ipv4, ipv6, ipv4ipv6 }
Default: ipv4
Internet protocol type - use both when no addresses are used,
otherwise define IPv4 and IPv6 rules for each type of addresses
used.
Synopsis: { ip, ipsec, firewall }
Default: ip
Prerequisite: ../iptype='ipv4ipv6'
Zone types applying to both IPv4 and IPv6: plain IP, firewall, or
IPSec
Synopsis: { ipv6, ipsec, firewall }
Default: ipv6
Prerequisite: ../iptype='ipv6'
Zone types are plain IPv6, firewall, or IPSec
Synopsis: { ipv4, ipsec, firewall }
Default: ipv4
Prerequisite: ../iptype='ipv4'
RUGGEDCOM ROX II
CLI User Guide
Section 5.17.8.2, "Adding
Adding a Zone