Table of Contents
Advertisement
Chapter 5
Setup and Configuration
Section 5.25.4
Enabling/Disabling a PIM-SM Interface
To enable or disable a PIM-SM interface, do the following:
NOTE
Enabling PIM-SM on an interface also enables IGMPv2 on the interface, wherein the interface with the
lowest IP address becomes the IGMP querier and sends periodic query messages every 125 seconds.
1.
Make sure the CLI is in Configuration mode.
2.
The interface is passive by default. Make it active for PIM-SM by typing:
no interface ifname passive
Where:
• ifname is the name of the interface
• passive determines whether the interface is passive (default) or active (no passive)
NOTE
A maximum of 30 non-passive interfaces can be active for PIM-SM.
3.
For VLAN interfaces only, if IGMP snooping is enabled on the interface, make sure the IGMP query interval
is set to 125 seconds. For more information, refer to
The same is required for any Layer 2 switches on the network.
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 5.25.5
Configuring a Static RP Address
To configure a Static RP address, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Add the RP address by typing:
routing multicast dynamic pim-sm rp-candidate static-address group-address priority number
Where:
• static-address is the Static RP (Rendezvous Point) address.
• group-address is the multicast group the RP handles.
• number sets the priority for this CRP. Smaller value means higher priority.
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.25.6
Managing a Boot Strap Router
The following sections describe how to configure and manage a Boot Strap Router:
416
Section 5.26.3.1, "Configuring IGMP
Enabling/Disabling a PIM-SM Interface
RUGGEDCOM ROX II
CLI User Guide
Snooping".
Advertisement
Table of Contents
Troubleshooting
