Table of Contents
Advertisement
Chapter 5
Setup and Configuration
Section 5.28.5.1
Viewing a List of Link Failover Ping Targets
To view a list of link failover ping targets, type:
show running-config services link-failover interface target
Where:
• interface is the name of the interface
If ping targets have been configured, a table or list similar to the following example appears:
R1-RX1512# show running-config services link-failover switch.0001 target
services
link-failover switch.0001
target 10.10.10.10
!
!
!
If no ping targets have been configured, add targets as needed. For more information, refer to
"Adding a Link Failover Ping
Section 5.28.5.2
Adding a Link Failover Ping Target
To add a link failover ping target, do the following:
NOTE
Link failover pings each target separately. If all targets are down, the main link is considered to be
down and it fails over to the backup interface. Backup links are used in the order of their Priority setting
(first, second, and then third), always starting with the first priority interface. When a higher-priority
interface becomes available again, the system reverts to the higher priority interface. For example, if
the second priority interface is active, the system switches back to the first priority interface when the
first priority interface becomes available again.
1.
Make sure the CLI is in Configuration mode.
2.
Add the ping target by typing:
services link-failover interface target address
Where:
• interface is the name of the interface
• address is the IP address of the target host to verify the main path
3.
Configure the following parameter(s) as required:
Parameter
{ host-ip }
454
Target".
Description
Synopsis: A string 7 to 15 characters long
The IP address of the target host to verify the main path.
Section 5.28.5.2,
Viewing a List of Link Failover Ping Targets
RUGGEDCOM ROX II
CLI User Guide
Advertisement
Table of Contents
Troubleshooting
