Table of Contents
Advertisement
RUGGEDCOM ROX II
CLI User Guide
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 3.16.4
Deleting an Event Tracker
To delete an event tracker, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Delete the event tracker by typing:
no global tracking event name
• name is the name of the tracking event
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 3.17
Managing Switched Ethernet Ports
The following sections describe how to configure and manage switched Ethernet ports:
•
Section 3.17.1, "Viewing a List of Switched Ethernet Ports"
•
Section 3.17.2, "Configuring a Switched Ethernet Port"
•
Section 3.17.3, "Configuring Port Security"
•
Section 3.17.4, "Viewing Switched Ethernet Port Statistics"
•
Section 3.17.5, "Viewing RMON Port Statistics"
•
Section 3.17.6, "Clearing Switched Ethernet Port Statistics"
•
Section 3.17.7, "Resetting a Switched Ethernet Port"
•
Section 3.17.8, "Testing Switched Ethernet Port Cables"
Section 3.17.1
Viewing a List of Switched Ethernet Ports
To view a list of switched Ethernet ports configured on the device, type:
show running-config interface switch
If switched Ethernet ports have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config interface switch
interface
switch lm1 1
auton
on
speed
auto
duplex
auto
switchport
no flow-control
no alias
rate-limiting
Deleting an Event Tracker
Chapter 3
Device Management
91
Advertisement
Table of Contents
Troubleshooting
