Chapter 5
Setup and Configuration
• For Switched Ethernet Ports
no switch vlans all-vlans id qosmap priority
Where:
▪ id is the ID given to the VLAN
▪ priority is the priority assigned to the QoS map
• For Routable Ethernet Ports
no interface eth slot port vlan id qosmap priority
Where:
▪ slot is the name of the module location
▪ port is the port number (or a list of ports, if aggregated in a port trunk) for the module
▪ id is the ID given to the VLAN
▪ priority is the priority assigned to the QoS map
• For Virtual Switches
no interface virtualswitch id vlan
Where:
▪ id is the ID of the virtual switch
▪ vlan-id is the ID given to the VLAN
▪ priority is the priority assigned to the QoS map
• For WAN Interfaces
no interface wan interface protocol channel number connection hdlc-eth vlan id qosmap priority
Where:
▪ interface is the WAN interface
▪ protocol is either T1 or E1
▪ number is the channel number
▪ id is the ID of the VLAN
▪ priority is the priority assigned to the QoS map
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.39.8
Managing Egress Markers for QoS Maps
Egress markers for QoS maps are used to assign priority to traffic that shares the same mark as one of the
egress marks configured for the device.
The following sections describe how to configure and manage egress markers for QoS maps:
•
Section 5.39.8.1, "Viewing a List of Egress Marks"
•
Section 5.39.8.2, "Adding an Egress Mark"
•
Section 5.39.8.3, "Deleting an Egress Mark"
586
vlan-id qosmap priority
RUGGEDCOM ROX II
CLI User Guide
Managing Egress Markers for QoS Maps