Adding A Neighbor - Siemens RUGGEDCOM ROX II User Manual

Chapter 5
Setup and Configuration
If no neighbors have been configured, add neighbors as needed. For more information, refer to
Section 5.22.12.2, "Adding a
Section 5.22.12.2

Adding a Neighbor

To add a new neighbor to an IPv4 address family, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the neighbor by typing:
routing bgp address-family ipv4 vrf vrf neighbor address
Where:
• vrf is the chosen VRF instance
• address is the IP address of the neighbor
3. Configure the neighbor settings by configuring the following parameter(s):
Parameter
send-community { send-community }
remote-as { remote-as }
ebgp-multihop { ebgp-multihop }
maximum-prefix { maximum-prefix }
next-hop-self
password { password }
update-source { update-source }
disable-connected-check
soft-reconfiguration
weight { weight }
4. Configure the route map settings by configuring the following parameter(s):
396
Neighbor".
Description
Synopsis: { standard, extended, both, none }
Default: both
Identifies the send Community. Default is both.
Synopsis: An integer between 1 and 65535
A BGP neighbor.
Synopsis: An integer between 1 and 255
The maximum hop count. This allows EBGP neighbors not on
directly connected networks.
Synopsis: An integer between 1 and 4294967295
The maximum prefix number accepted from this peer.
Synopsis: typeless
Disables the next hop calculation for this neighbor.
Synopsis: A string 1 to 1024 characters long
Password.
Synopsis: A string 7 to 15 characters long
Source IP address of routing updates.
Synopsis: typeless
Disables connection verification when establishing an eBGP
peering session with a single-hop peer that uses a loopback
interface.
Synopsis: typeless
Per neighbor soft reconfiguration.
The default weight for routes from this neighbor.
RUGGEDCOM ROX II
CLI User Guide
Adding a Neighbor