RUGGEDCOM ROX II
CLI User Guide
NOTE
While DHCP Relay and DHCP Server may both be configured to run concurrently, they may not be
configured to run on the same network interface.
To configure the DHCP relay agent, do the following:
•
Section 5.14.1, "Configuring the DHCP Relay Agent"
•
Section 5.14.2, "Viewing a List of DHCP Client Ports"
•
Section 5.14.3, "Adding DHCP Client Ports"
•
Section 5.14.4, "Deleting a DHCP Client Port"
Section 5.14.1
Configuring the DHCP Relay Agent
To configure the DHCP relay agent, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Configure the following parameter(s) as required:
Parameter
dhcp-server-address { dhcp-server-address }
3.
Add client ports. For more information, refer to
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 5.14.2
Viewing a List of DHCP Client Ports
To view a list of DHCP relay agent client ports, type:
show running-config switch dhcp-relay-agent dhcp-client-ports
If client ports have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config switch dhcp-relay-agent dhcp-client-ports
switch dhcp-relay-agent
dhcp-client-ports lm1 1
!
!
If no client ports have been configured, add client ports as needed. For more information, refer to
"Adding DHCP Client
Configuring the DHCP Relay Agent
Ports".
Description
Synopsis: A string
The IP address of the DHCP server to which DHCP queries will
be forwarded from this relay agent.
Section 5.14.3, "Adding DHCP Client
Chapter 5
Setup and Configuration
Ports".
Section 5.14.3,
235