Viewing Flash Card Storage Utilization - Siemens RUGGEDCOM ROX II User Manual

Chapter 3
Device Management
---------------------------------------------------------------------------------
main RX1501 8 Gigabit Layer 3 w/ 6 LM slots and 1 PM slots
This table or list provides the following information:
Parameter
slot
detected-module
boot-loader-version
fpga-version
Section 3.2.3

Viewing Flash Card Storage Utilization

To view the Flash card storage utilization statistics for the Flash card installed in the device, type:
show chassis storage
A table or list similar to the following example appears:
ruggedcom# show chassis storage | tab
storage
flash
storage name
total capacity
current partition
current partition capacity
secondary partition capacity 490496
current partition usage
This table or list provides the following information:
Parameter
storage-name
total-capacity
current-partition
current-partition-capacity
secondary-partition-capacity
current-partition-usage
52
Description
Synopsis: { ---, pm1, pm2, main, sm, lm1, lm2, lm3, lm4, lm5, lm6, swport, eth, serport,
celport, cm, em, trnk }
The slot name, as marked on the silkscreen across the top of the chassis.
Synopsis: A string 1 to 60 characters long
The installed module's type specifier.
Synopsis: A string
The version of the ROX bootloader software on the installed module.
Synopsis: A string
The version of the ROX FPGA firmware (if any) running on the installed module.
"Compact Flash"
994896
"Partition #1"
490496
67
Description
Synopsis: A string 0 to 32 characters long
The type of storage.
Synopsis: An integer between 0 and 4294967295
The total capacity of the flash storage in KB.
Synopsis: A string 0 to 32 characters long
The partition ROX is currently running on and booted from.
Synopsis: An integer between 0 and 4294967295
The capacity of the current partition in KB.
Synopsis: An integer between 0 and 4294967295
The capacity of the secondary partition in KB.
Synopsis: An integer between 0 and 100
2010.09RR12 14-23
Viewing Flash Card Storage Utilization
RUGGEDCOM ROX II
CLI User Guide