Deleting A Masquerade Or Snat Setting - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
NOTE
Masquerading requires that the IP address being used to masquerade must belong to the router.
When configuring the SNAT address under masquerading, the SNAT address must be one of the IP
addresses on the outbound interface.
1. Make sure the CLI is in Configuration mode.
2. Add the masquerade or SNAT setting by typing:
security firewall fwconfig firewall fwmasq name
Where:
• firewall is the name of the firewall
• name is the name of the masquerade or SNAT setting
3. Configure the following parameter(s) as required:
Parameter
iptype { iptype }
out-interface { out-interface }
out-interface-specifics { out-interface-specifics }
ipalias
source-hosts { source-hosts }
address { address }
description { description }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 5.17.13.3

Deleting a Masquerade or SNAT Setting

To delete a masquerade or SNAT setting, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the masquerade or SNAT setting by typing:
no security firewall fwconfig firewall fwmasq name
Where:
Deleting a Masquerade or SNAT Setting
Description
Synopsis: { ipv4, ipv6, ipv4ipv6 }
Default: ipv4
Internet protocol type - use both when no addresses are used,
otherwise define IPv4 and IPv6 rules for each type of addresses
used.
An outgoing interface list - usually the internet interface.
Synopsis: A string
(Optional) An outgoing interface list - specific IP destinations for
the out-interface.
Synopsis: typeless
Create IP Alias for NAT rule.
Synopsis: A string
Subnet range or comma-separated list of hosts (IPs)
Synopsis: A string
(Optional) By specifying an address here, SNAT will be used and
this will be the source address.
Synopsis: A string
(Optional) The description string for this masq entry.
Chapter 5
Setup and Configuration
289