Siemens RUGGEDCOM ROX II User Manual page 131

RUGGEDCOM ROX II
CLI User Guide
NOTE
Switched Ethernet ports in dedicated routing port mode cannot be trunk ports.
NOTE
The configuration for a switched Ethernet port in switchport mode can be restored when it is
removed from a trunk. However, the configuration cannot be restored if the port is in dedicated
routing mode.
Parameter
enabled
auton { auton }
speed { speed }
duplex { duplex }
link-alarms
switchport
flow-control
on-demand
lfi
ip-address-src { ip-address-src }
Configuring a Switched Ethernet Port
Description
Synopsis: true or false
Default: true
Provides the option to enable or disable this interface. When
unchecked(i.e disabled), the interface will prevent all frames from
being sent and received on that interface.
Enables or disables IEEE 802.3 auto-negotiation. Enabling
auto-negotiation results in speed and duplex being negotiated
upon link detection; both end devices must be auto-negotiation
compliant for the best possible results.
Speed (in megabits-per-second or gigabits-per-second). If auto-
negotiation is enabled, this is the speed capability advertised
by the auto-negotiation process. If auto-negotiation is disabled,
the port is explicitly forced to this speed mode. AUTO means
advertise all supported speed modes.
If auto-negotiation is enabled, this is the duplex capability
advertised by the auto-negotiation process. If auto-negotiation is
disabled, the port is explicitly forced to this duplex mode. AUTO
means advertise all supported duplex modes.
Synopsis: true or false
Default: true
Disabling link-alarms will prevent alarms and LinkUp and
LinkDown SNMP traps from being sent for that interface. Link
alarms may also be controlled for the whole system under
admin / alarm-cfg.
Synopsis: true or false
Sets the physical port into either switched mode or a dedicated
routing mode.
Synopsis: typeless
Flow control is useful for preventing frame loss during times of
severe network traffic
Synopsis: typeless
Bring up this interface on-demand only
Synopsis: typeless
Link Fault Indication (LFI) is specifically for FX interfaces.
Synopsis: { static, dynamic }
Whether the IP address is static or dynamically assigned via
DHCP or BOOTP. Option DYNAMIC is a common case of a
dynamically assigned IP address. It switches between BOOTP
and DHCP until it gets the response from the relevant server.
This must be static for non-management interfaces.
Chapter 3
Device Management
93