Chapter 5
Setup and Configuration
4.
Configure the VLAN for the port. For more information, refer to
Switch Ethernet
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
5.
Section 5.37.4.3
Deleting a Static VLAN
To delete a static VLAN for either a routable Ethernet port or virtual switch, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Delete the static VLAN by typing:
no switch vlans static-vlan id
Where:
• id is the ID of the VLAN
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.37.5
Managing Forbidden Ports
Static VLANs can be configured to exclude ports from membership in the VLAN using the forbidden ports list.
The following sections describe how to configure and manage a list of forbidden ports:
•
Section 5.37.5.1, "Viewing a List of Forbidden Ports"
•
Section 5.37.5.2, "Adding a Forbidden Port"
•
Section 5.37.5.3, "Deleting a Forbidden Port"
Section 5.37.5.1
Viewing a List of Forbidden Ports
To view a list of forbidden ports, type:
show running-config switch vlans static-vlan forbidden-ports
If ports have been forbidden, a table or list similar to the following example appears:
ruggedcom# show running-config switch vlans static-vlan forbidden-ports | tab
VID
SLOT
PORT
-----------------
50
lm1
1
lm1
2
60
lm1
2
lm1
3
lm1
4
70
lm1
5
!
552
Ports".
Section 5.37.3.2, "Configuring VLANs for
RUGGEDCOM ROX II
CLI User Guide
Deleting a Static VLAN