Adding A Channel - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
wan lm2 1
t1 channel 2
connection ppp nomagic
!
!
!
If no channels have been configured, add channels as needed. For more information, refer to
"Adding a Channel".
Section 3.23.9.2

Adding a Channel

To configure a channel for a T1/E1 physical interface, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the channel by typing:
interface wan slot port protocol channel number
Where:
• slot is the name of the module location
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module
• protocol is either T1 or E1
• number is the channel number
3. Configure the following parameter(s) as required:
Parameter
{ channelnumber }
ts { ts }
4. If necessary, configure VLANs for an HDLC-ETH connection. For more information, refer to
"Adding an HDLC-ETH
5. If necessary, configure an MLPPP connection. For more information, refer to
Multi Link PPP
6. If necessary, configure a PPP connection. For more information, refer to
Connection".
7. If necessary, configure a frame relay connection. For more information, refer to
a Frame Relay
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
8.
Adding a Channel
Description
Synopsis: An integer between 1 and 24
Channel Number.
Synopsis: A string 0 to 128 characters long
Default: all
Time slots for this channel. Format: the string 'all', or a comma-separated list of numbers
in the range of 1 to 24. To specify a range of numbers, separate the start and end of the
range with '..' or with a hyphen '-' Example 1: 1,2,3 and 1..3 both represent time slots 1
through 3. Example 2: 1,2,5..10,11 represents time slots 1, 2, 5, 6, 7, 8, 9, 10, and 11.
VLAN".
Connection".
Connection".
Device Management
Section 3.23.9.2,
Section 5.37.6.2,
Section 3.23.11, "Configuring a
Section 3.23.12, "Configuring a PPP
Section 3.23.13, "Configuring
Chapter 3
139