RUGGEDCOM ROX II
CLI User Guide
▪ mark is the value of the egress mark
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.39.8.3
Deleting an Egress Mark
To delete an egress mark for a QoS map, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Delete the QoS map for the VLAN connection by typing:
• For Switched Ethernet Ports
no interface switch vlans all-vlans id qosmap priority egress mark
Where:
▪ id is the ID given to the VLAN
▪ priority is the priority assigned to the QoS map
▪ mark is the value of the egress mark
• For Routable-Only Ethernet Ports
no interface eth slot port vlan id qosmap priority egress mark
Where:
▪ slot is the name of the module location
▪ port is the port number (or a list of ports, if aggregated in a port trunk) for the module
▪ id is the ID given to the VLAN
▪ priority is the priority assigned to the QoS map
▪ mark is the value of the egress mark
• For Virtual Switches
no interface virtualswitch id vlan vlan-id qosmap priority egress mark
Where:
▪ slot is the name of the module location
▪ port is the port number (or a list of ports, if aggregated in a port trunk) for the module
▪ id is the ID given to the VLAN
▪ priority is the priority assigned to the QoS map
▪ mark is the value of the egress mark
• For WAN Interfaces
no interface wan slot port vlan id qosmap priority egress mark
Where:
▪ slot is the name of the module location
▪ port is the port number (or a list of ports, if aggregated in a port trunk) for the module
▪ id is the ID given to the VLAN
Deleting an Egress Mark
Chapter 5
Setup and Configuration
589