Chapter 5
Setup and Configuration
is-type
metric-style
area-authorization
area-password
area-authentication
domain-authorization
domain-password
domain-authentication validate
net 49.0001.1921.6800.1001.00
!
redistribute bgp
is-type
level-1-2
metric-type internal
metric
10
!
lsp-gen-interval is-type level-1-only
interval 60
!
lsp-refresh-interval is-type level-1-2
interval 20
!
max-lsp-lifetime is-type level-2-only
interval 10
!
spf-interval is-type level-1-2
interval 5
!
!
!
If no area tags have been configured, add area tags as needed. For more information, refer to
"Adding an Area
Tag".
Section 5.18.5.2
Adding an Area Tag
To add an area tag for dynamic IS-IS routes, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Add the area by typing:
routing isis area name
Where:
• name is the unique name for a routing process that belongs to a specific router.
3.
Configure the following parameter(s) as required:
Parameter
is-type { is-type }
metric-style { metric-style }
300
level-1-2
narrow
md5
admin
validate
md5
admin
Description
Synopsis: { level-1-only, level-2-only, level-1-2 }
The IS type for this area: level-1-only, level-2-only or level-1-2.
Level-1 routers have neighbors only on the same area. Level-2-
only (backbone) can have neighbors on different areas. Level-1-2
can have neighbors on any areas. Default is level-1-2.
Synopsis: { narrow, transition, wide }
Default: wide
The metric style Type Length Value (TLV) for this area: narrow,
transition or wide. Default is wide.
RUGGEDCOM ROX II
CLI User Guide
Section 5.18.5.2,
Adding an Area Tag