RUGGEDCOM ROX II
CLI User Guide
abort
0
corruption
0
pcierror
0
dmaerror
0
.
.
.
This table or list provides the following information:
Parameter
slot
port
channelno
state
local
remote
mask
reliability
create-time
last-status-change
For information about clearing the WAN statistics, refer to
Section 3.23.4
Clearing WAN Statistics
The following describes how to clear the statistics collected when WAN interfaces are enabled. All of the statistics
or only those for a interface can be cleared.
To clear statistics for all WAN interfaces, type:
interfaces wan clearstatistics all-interfaces
Clearing WAN Statistics
Description
Synopsis: { sm, lm1, lm2, lm3, lm4, lm5, lm6, swport, eth, serport,
celport } or a string
Line module name of the slot.
Synopsis: An integer between 1 and 16 or a string
Port number on the slot.
Synopsis: An integer between 1 and 32 or a string
Channel number on the port.
Synopsis: { not set, up, down, testing, unknown, dormant,
notPresent, lowerLayerDown }
Status of the interface.
Synopsis: A string
Loacal IP address of the interface.
Synopsis: A string
Peer IP address.
Synopsis: A string
Netmask.
Synopsis: A string
Reliability of the interface over 5 minutes. It is calculated as an
exponential average
of the fraction of the total received and transmitted errors and the
total packets that
are received and transmitted successfully.
Synopsis: A string
The duration of time since interface is created.
Synopsis: A string
The duration of time since last change of interface status.
Section 3.23.4, "Clearing WAN
Chapter 3
Device Management
Statistics".
135