Viewing A List Of Virtual Switch Interfaces; Adding A Virtual Switch Interface - Siemens RUGGEDCOM ROX II User Manual

Chapter 3
Device Management
Section 3.24.4.1

Viewing a List of Virtual Switch Interfaces

To view a list of virtual switch interfaces, type:
show running-config interface virtualswitch name interface
Where:
• name is the name assigned to the virtual switch
If switches have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config interface virtualswitch vs1 interface | tab
NAME
-----------------
switch.0100
te1-4-1c01.0100
!
!
If no virtual switches have been configured, add switches as needed. For more information, refer to
Section 3.24.2, "Adding a Virtual
Section 3.24.4.2

Adding a Virtual Switch Interface

To add a virtual switch interface, do the following:
IMPORTANT!
At least two interfaces are required for a virtual switch bridge.
CAUTION!
Accessibility hazard – risk of access disruption. Do not select the interface used to the access the Web
interface. Active Web sessions will be lost and the Web interface will be unreachable until the virtual
switch is disabled.
1. Make sure the CLI is in Configuration mode.
2. Add the virtual switch by typing:
interface virtualswitch name interface interface
Where:
• name is the name assigned to the virtual switch
• interface is the name assigned to the interface
The new interface is now accessible by typing:
ip vsw-name
The name of the interface is the name of the virtual switch preceded by vsw- (i.e. vsw-vs1, vsw-vs2, etc.).
3. Assign an IPv4 or IPv6 address to the interface. For more information, refer to
IPv4 Address"
4. If necessary, add one or more VLANs to the virtual switch interface. For more information, refer to
Section 5.37.7.2, "Adding a Virtual Switch
148
Switch".
or Section 5.40.6.2, "Adding an IPv6 Address".
VLAN".
CLI User Guide
Section 5.40.3.2, "Adding an
Viewing a List of Virtual Switch Interfaces
RUGGEDCOM ROX II