Chapter 5
Setup and Configuration
Section 5.31.8.1
Viewing a List of IP Addresses
To view a list of remote L2 protocol server IP addresses for a generic tunnel configuration, type:
show running-config tunnel l2tunneld generic tunnel remote-daemon
If tunnels have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config tunnel l2tunneld generic tunnel remote-daemon ip-address | tab
NAME
IP ADDRESS
--------------------
1
172.112.10.1
!
If no generic tunnels have been configured, add tunnels as needed. For more information, refer to
Section 5.31.7.3, "Adding a Generic
Section 5.31.8.2
Adding an IP Address
To add the IP address of a remote L2 protocols server to a generic tunnel configuration, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Add the IP address by typing:
tunnel l2tunneld generic tunnel name remote-daemon ip-address address
Where:
• name is the name of the generic tunnel
• address is the IP address of the remote L2 protocols server
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.31.8.3
Deleting an IP Address
To delete the IP address of a remote L2 protocols server from a generic tunnel configuration, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Delete the IP address by typing:
no tunnel l2tunneld generic tunnel name remote-daemon ip-address address
Where:
• name is the name of the generic tunnel
• address is the IP address of the remote L2 protocols server
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
488
Tunnel".
RUGGEDCOM ROX II
CLI User Guide
Viewing a List of IP Addresses