Viewing The Status Of Static Cross-Connects; Viewing A List Of Static Cross-Connects - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
• Section 5.41.6.2, "Viewing a List of Static Cross-Connects"
• Section 5.41.6.3, "Adding a Static Cross-Connect"
• Section 5.41.6.4, "Deleting a Static Cross-Connect"
Section 5.41.6.1

Viewing the Status of Static Cross-Connects

To view the status of all configured static cross-connects, type:
show mpls status static-crossconnect
If static cross-connects have been configured, a table similar to the following example appears:
ruggedcom# show mpls status static-crossconnect
LOCAL OUTGOING
LABEL LABEL
--------------------------------------------
200 205
215 250
This table provides the following information:
Parameter
local-label
outgoing-label
outgoing-interface
next-hop
If no static cross-connects have been configured, add cross-connects as needed. For more information about
adding static cross-connects, refer to
Section 5.41.6.2

Viewing a List of Static Cross-Connects

To view a list of configured static cross-connects, type:
show running-config mpls static-mpls crossconnects
If static cross-connects have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config mpls static-mpls crossconnect | tab
OUT
LABEL INTERFACE
-----------------------------------------
20 switch.0001
!
!
Viewing the Status of Static Cross-Connects
OUTGOING
INTERFACE NEXT HOP
switch.0010 192.168.10.2
switch.0010 192.168.10.2
Section 5.41.6.3, "Adding a Static
OUT
NEXT HOP LABEL
192.168.10.2 32
Description
Synopsis: A string
The incoming (local) label.
Synopsis: A string
The outgoing (remote) label.
Synopsis: A string
The outgoing interface.
Synopsis: A string
The destination next hop router.
Cross-Connect".
Chapter 5
Setup and Configuration
605