RUGGEDCOM ROX II
CLI User Guide
Parameter
priority { priority }
transfer-default-route
backup-gateway { backup-gateway }
on-demand
Section 5.28.4.3
Deleting a Link Failover Backup Interface
To delete a link failover backup interface, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Delete the backup interface by typing:
no services link-failover interface backup backup-interface
Where:
• interface is the name of the interface
• backup-interface is the name of the secondary, backup interface
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.28.5
Managing Link Failover Ping Targets
A link failover ping target is an IP address that link failover pings to determine if the main link is down. The
address can be a dedicated host or a dummy address on a router. Up to three link failover ping targets can be
added to each link failover configuration.
The following sections describe how to configure and manage ping targets for link failover protection:
•
Section 5.28.5.1, "Viewing a List of Link Failover Ping Targets"
•
Section 5.28.5.2, "Adding a Link Failover Ping Target"
•
Section 5.28.5.3, "Deleting a Link Failover Ping target"
Deleting a Link Failover Backup Interface
Description
Synopsis: { third, second, first }
Default: first
The priority which is applied to the backup interface when
switching.
Synopsis: typeless
The transfer default gateway on the switching main and
backup interface. The default route on the device must have a
<emphasis>distance</emphasis> greater than one.
Synopsis: A string 1 to 15 characters long
The IP address of the backup gateway.
Synopsis: true or false
Displays the status of the interface's On-demand option. When
enabled, link failover can set the interface to up or down as
needed. The interface is down until needed by link failover. When
disabled, link failover cannot set the interface to up or down. By
default, the interface is always up.
Chapter 5
Setup and Configuration
453