Adding A Forbidden Port; Deleting A Forbidden Port; Managing Vlans For Hdlc-Eth Connections - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
If no ports have been forbidden, add forbidden ports as needed. For more information, refer to
"Adding a Forbidden
Section 5.37.5.2

Adding a Forbidden Port

To add a forbidden port, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the forbidden port by typing:
switch vlans static-vlan name forbidden-ports slot port
Where:
• name is the name of the static VLAN
• slot is the name of the module location
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.37.5.3

Deleting a Forbidden Port

To delete a forbidden port, do the following:
1. Make sure the CLI is in Configuration mode.
2. Configure the following parameter(s) as required:
no switch vlans static-vlan name forbidden-ports slot port
Where:
• name is the name of the static VLAN
• slot is the name of the module location
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.37.6

Managing VLANs for HDLC-ETH Connections

VLANs can be used to create logical separations between multiple HDLC-ETH connections within a T1 or E1
channel.
NOTE
Frames egressed through this logical interface will not be tagged with the VLAN configured for the
HDLC-ETH connection.
The following sections describe how to configure and manage VLANs for HDLC-ETH connections:
• Section 5.37.6.1, "Viewing a List of HDLC-ETH VLANs"
Adding a Forbidden Port
Port".
Chapter 5
Setup and Configuration
Section 5.37.5.2,
553