Adding A Policy - Siemens RUGGEDCOM ROX II User Manual

Chapter 5
Setup and Configuration
ruggedcom# show running-config security firewall fwconfig firewall1 fwpolicy
security
firewall
fwconfig firewall1
fwpolicy p1
description Policy
!
!
!
!
If no policies have been configured, add policies as needed. For more information, refer to
"Adding a Policy".
Section 5.17.11.2

Adding a Policy

To configure a policy for the firewall, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the policy by typing:
security firewall fwconfig firewall fwpolicy policy
Where:
• firewall is the name of the firewall
• policy is the name of the policy
3. Configure the following parameter(s) as required:
Parameter
iptype { iptype }
policy { policy }
log-level { log-level }
description { description }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
284
Description
Synopsis: { ipv4, ipv6, ipv4ipv6 }
Default: ipv4
Internet protocol type - use both when no addresses are used,
otherwise define IPv4 and IPv6 rules for each type of addresses
used.
Synopsis: { accept, drop, reject, continue }
Default: reject
A default action for connection establishment between different
zones.
Synopsis: { none, debug, info, notice, warning, error, critical,
alert, emergency }
Default: none
(Optional) Determines whether or not logging will take place and
at which logging level.
Synopsis: A string
(Optional) The description string for this policy.
RUGGEDCOM ROX II
CLI User Guide
Section 5.17.11.2,
Adding a Policy