Deleting A Remote Daemon; Managing Generic Tunnels; Viewing The Generic Tunnel Statistics - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.31.6.3

Deleting a Remote Daemon

To delete a remote daemon, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the remote daemon typing:
no tunnel l2tunneld goose tunnel name remote-daemon address
Where:
• name is the name of the GOOSE tunnel
• address is the IP address of the remote daemon
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.31.7

Managing Generic Tunnels

The Layer 2 Tunnel Daemon supports a generic mode of operation based on the Ethernet type of Layer 2 data
traffic seen by the router. Multiple tunnels may be configured, each one with:
• an Ethernet type
• a tunnel ingress (Ethernet interface)
• a tunnel egress (either another locally connected Ethernet interface, or the remote IP address of another Layer
2 Tunnel daemon instance running on another Router)
The following sections describe how to configure and manage generic tunnels:
• Section 5.31.7.1, "Viewing the Generic Tunnel Statistics"
• Section 5.31.7.2, "Viewing a List of Generic Tunnels"
• Section 5.31.7.3, "Adding a Generic Tunnel"
• Section 5.31.7.4, "Deleting a Generic Tunnel"
Section 5.31.7.1

Viewing the Generic Tunnel Statistics

To view the generic tunnel statistics, type:
show tunnel l2tunneld status generic
A table or list similar to the following example appears:
ruggedcom# show tunnel l2tunneld status generic
TUNNEL
NAME IFNAME
ERRORS
---------------------------------------------------------------------------------------------
iso switch.0002
Deleting a Remote Daemon
RX TX RX
FRAMES FRAMES CHARS
5 6 300
TX
CHARS ERRORS REMOTE IP
360 0
Setup and Configuration
RX TX RX
PACKETS PACKETS BYTES
Chapter 5
TX
BYTES
485