RUGGEDCOM ROX II
CLI User Guide
Section 5.18.10.1
Viewing a List of LSP Refresh Intervals
To view a list of LSP refresh intervals configured for an IS-IS area, type:
show running-config routing isis area name lsp-refresh-interval
Where:
• name is the unique name for a routing process that belongs to a specific router.
If intervals have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing isis area Area_1 lsp-refresh-interval | tab
ISTYPE
INTERVAL
------------------------
level-1-only
60
!
!
If no intervals have been configured, add intervals as needed. For more information, refer to
"Adding an LSP Refresh
Section 5.18.10.2
Adding an LSP Refresh Interval
To add an LSP refresh interval to an IS-IS area, do the following:
IMPORTANT!
The LSP refresh interval must be 300 seconds less than the LSP lifetime interval. For more information
about LSP refresh intervals, refer to
1.
Make sure the CLI is in Configuration mode.
2.
Add a new interval by typing:
routing isis area name lsp-refresh-interval is-type [ level-1-2 | level-1-only | level-2-only ]
interval seconds
Where:
• name is the unique name for a routing process that belongs to a specific router.
• level is the IS type.
• seconds is the minimum interval in seconds, ranging from 1 to 120. The default value is 30.
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.18.10.3
Deleting an LSP Refresh Interval
To delete an LSP refresh interval for an IS-IS area, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Delete the LDP interface by typing:
Viewing a List of LSP Refresh Intervals
Interval".
Section 5.18.9, "Managing the Lifetime of
Chapter 5
Setup and Configuration
Section 5.18.10.2,
LSPs".
309