Deleting A Cdma Profile - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Parameter
username { username }
password { password }
dial-on-demand
disconnect-idle-timeout { disconnect-idle-timeout }
failover-on-demand
mtu { mtu }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
5.
Section 5.13.1.3

Deleting a CDMA Profile

To delete a CDMA Profile, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the chosen key by typing:
no global cellular profiles cdma name
Where:
• name is the name of the profile
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Deleting a CDMA Profile
Description
Enables the DNS server entries that the PPP server
recommends. Enables this option unless you provide your own
name servers.
Synopsis: A string
Default: N/A
The user ID to connect to the remote server.
Synopsis: A string
Default: N/A
The password to be authenticated by the remote server.
Synopsis: typeless
Activates dial-on-demand for this connection. The establishment
of the PPP connection is postponed until there is data to be
transmitted via the interface. If dial-on-demand is configured,
Failover on Demand cannot be configured.
Prerequisite: If dial-on-demand is configured, Failover on
Demand cannot be configured.
Default: 0
The time in seconds to wait before disconnecting PPP when
there is no traffic on the link. This option is only valid when dial-
on-demand is enabled.
Synopsis: typeless
Activates link failover on-demand on this device. PPP link
establishment on this device is controlled by link failover. If
Failover on Demand is configured, Dial on Demand cannot be
configured.
Prerequisite: If link failover on-demand is configured, Dial on
Demand cannot be configured.
Synopsis: An integer between 128 and 1500
Default: 1500
MTU (Maximum Transmission Unit) value on a PPP interface.
Chapter 5
Setup and Configuration
231