Configuring The Role - Brocade Communications Systems RFS6000 System Reference Manual

6
5. To enable a Denial of Service Attack filter, select a disabled rule from the table and click the
6. To disable a Denial of Service Attack filter, select an enabled rule from the table and click the
NOTE
Of the 28 DoS Attack filters supported by the switch, 10 can be disabled individually. Those filters
are:
- Smurf
- Twinge
- Invalid IP protocol
- ICMP router advertisement
- Src ip route
- Echo ports
- Snork
- FTP bounce
- TCP intercept
- Bcast Mcast ICMP
7.
8. To disable all Denial of Service Attack filters, click on the Disable All button. When a DoS Attack
9. To clear statistics for Denial of Service Attacks, click the Clear Stats button. This will reset all
10. Click the Apply button to save the changes made within the DoS Attach screen.
11. Click the Revert button to cancel any changes made within the DoS Attach screen and revert

Configuring the Role

To view configured roles:
1. Select Security > Wireless Firewall from the main tree menu.
2. Click the Configuration tab.
374
Enable button.The Check Enabled field will show a green checkmark next to the Denial of
Service Attack filters that are enabled on the switch firewall.
Disable button. When a DoS Attack filter is disabled a red "X" will be shown in the Check
Enabled column.
To enable all Denial of Service Attack filters, click on the Enable All button.The Check Enabled
field will show a green checkmark next to the Denial of Service Attack filters that are enabled
on the switch firewall.
filter is disabled a red "X" will be shown in the Check Enabled column.
Attack Counts to 0 and all Last Occurrence times to 0:00:00.00.
back to the last saved configuration.
Brocade Mobility RFS4000, RFS6000, and RFS7000 System Reference Guide
53-1002515-01