Brocade Communications Systems RFS6000 System Reference Manual page 188

4
Port Authentication
To configure the port authentication settings on an Access Port:
1. Select Network > Access Port Radios from the main menu tree.
2. Click the Configuration tab.
3. Click the Global Settings button.
4. Click the Configure Port Authentication button.
5. Enter the 802.1x Username assigned to the Access Port.
6. Enter the 802.1x Password (for the corresponding username) providing authorization for
NOTE
The default user name and password for Brocade Mobility 300 Access Point port authentication is
a user name of admin and a password of symbol.
7.
NOTE
802.1x username and password information is only passed to adopted Access Ports when the
Username and Password are set. Any AP adopted after this does not automatically receive a
username and password.
NOTE
After setting the username and password to factory default settings, the system must be rebooted
before the factory default settings are applied.
8. Refer to the Status field for the current state of the requests made from applet. This field
9. Click OK to use the changes to the running configuration and close the dialog.
176
Access Port authorization adoption.
Check the Use Default Values option checkbox to set the Username and Password to factory
default values. The Access Port can get disconnected if the 802.1x authenticator is not
configured accordingly.
displays error messages if something goes wrong in the transaction between the applet and
the switch.
Brocade Mobility RFS4000, RFS6000, and RFS7000 System Reference Guide
53-1002515-01