Brocade Communications Systems RFS6000 System Reference Manual page 460

6
2. Select the Probe Table tab.
3. Select the Enable Enhanced Probe Table checkbox to allow an AP to forward client probe
4. Define a Window Time (from 10 to 60 seconds) to set an interval used by the AP to record
5. Set a Maximum Numbers of client's (from 0 to 512) to define the number of Clients configured
6. The Preferred Clients table lists the MAC Addresses for all preferred Clients.
7.
8. Click the Add button to open a dialogue and add the MAC Address of a preferred client to the
9. 802.11a Radios: Click the Enable All button to allow an AP's 802.11a radio to receive client
10. 802.11a Radios: Click the Disable button to stop AP's 802.11a radios from forwarding client
11. 802.11bg Radios: Click the Enable button to allow the AP's 802.11bg radios to receive client
12. 802.11bg Radios: Click the Disable button to stop AP's 802.11bg radios from forwarding client
13. Click Apply to save any changes. Navigating away from the screen without clicking the Apply
14. Click the Revert button to undo the changes to the screen and revert to the last saved
448
requests to the switch.
client probe requests. The client radio probe entry with the highest signal strength during the
window period is recorded in the table.
in the switch table. The default is 50 Clients.
Select a client from the Preferred Clients table and click the Delete button to remove the client
from the table.
table.
probe requests and forward them to the switch.
probe requests to the switch.
probe requests and forward them to the switch.
probe requests to the switch.
button results in all the changes on the screen being discarded.
configuration.
Brocade Mobility RFS4000, RFS6000, and RFS7000 System Reference Guide
53-1002515-01